Modifying the brand new fuel cell to fit my build

Pictures from when installing my tube front end

Some pics from when I squared my k-member

Tools required: Plumb bobs Tape Marker Tape measure Squaring up the k-member is a fairly simple process You find a spot in the rear to attach your plum bobs, make sure you can attach it to the same place on both sides. I used the inside of the upper control arm brackets. Passenger side shown. Underneath the plumbob you put a piece of tape and put a dot directly under the point once it stops moving.

Repairing my frame rail, because it was rusted out.

Photos while installing my TeamZ roll cage

Installing the TeamZ coilover bar