Measuring the space between the cage rear cross bar and coilover bar
The cell was advertised at 17" won't fit as I wanted
Had to pull the gas cap off
Needed to get access to the foam inside to remove it
Can see the sump with the foam removed
Cut lines, 1" deep, 4.5" high
Decently straight cuts
Initial fitup of the front piece
Initial fiup of the front piece (side)
The weld pulled the front piece out of square
We'll make the messup work, it happens.
Need to trim the front piece back still
Cut line for the front piece
A little bit to much of a gap to fill I felt
Angled the front just a little bit to close the gap up a bit
Tacked everything in place
Fully finished product, it actually held water!!!
