Looking from inside the engine bay at the frame, cut open the first layer
Another angle
Cutting out the inner layer
Showing the outer skin and the inner layer
Back side this is the top plate
Starting to fab my new frame on 12ga steel
Nothing too special
Clamping the piece I cut out to the new piece
Used spray paint from the top to mark where to mount the new reinforcements
The left one should have been more left.But not too bad
I added the 2 middle tubes for support, and added a cuople of braces to the tubes that the kmember bolts will go through
View from the front
Welded into the frame
Installing the new top plate
Needed to bevel the dge ever so slightly
Large gap between the k-member and the new frame
