Frame already at 16 1/4" maybe no cutting required
Both sides even
Showing where I'm measuring from
Bottom cut off before shot
Before shot
Cut line
Too wide for the frame
Extra piece of metal on the inside
Cutting the bottom flush
That extra piece of metal I'm going to remove
Cut out the rused triangle piece
Cutting further back
Test fitting the fender, the driver side is really low
Angled way down
Got the angles corrected and test fit the front end
Helt it all together with clamps
Can't wait for her to be done!
What it looks like on the inside, look at all that room
Might just ben enough froom for an intercooler in there......
Frame where the kmember bolts through is rotten
Cutting out the old frame
There is an inner layer, and an outter layer
Cutting from the back side
New frame being made out of 12 ga steel
Claming the old piece to the new one to mark the holes for drilling
Used spray paint to mark the holes
The left side should have been moved over about 3/8" to the left
Welds
primed and installed
Fully welded in
New top piece on the back side
